Prime Tower

Post Reply
choadicus
Posts: 18
Joined: Tue May 28, 2019 11:02 pm

Prime Tower

Post by choadicus » Tue Dec 31, 2019 2:44 am

Hi,

I have a Geeetech A10M. I am using Cura 4.4 printing slicer. I change the values to work with my Geeetech and everything works great except the prime tower. It start off great and then almost half way done the middle of the prime tower stop building right. You can see from the photo outside is great but the middle is not printing right. Please help . I love this slicer.
Attachments
IMG_20191229_113812.jpg
IMG_20191229_113812.jpg (248.41 KiB) Viewed 3820 times

Jarda3d
Posts: 189
Joined: Sat Jan 26, 2019 8:42 am

Re: Prime Tower

Post by Jarda3d » Tue Dec 31, 2019 4:56 am

Did you render gcode? Is tower full or is broken in gcode?

Restart Cura, your OS... repeat slicing.... look at gcode.
A10M Slic3r profile: here and fresh on github (lot of tips here)
A10 Slic3r profile: here
TIP: tight all screws and wheels (except right side of Z axis) and re-align frame while assembly. And silence it.

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Prime Tower

Post by William » Tue Dec 31, 2019 9:53 am

:D Hi, You can view your configuration and re-slice it for printing.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

choadicus
Posts: 18
Joined: Tue May 28, 2019 11:02 pm

Re: Prime Tower

Post by choadicus » Wed Jan 01, 2020 12:09 am

How do i do that?

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Prime Tower

Post by William » Wed Jan 01, 2020 5:28 pm

:D Hi, You can try to reset it and slice it.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply