Geeetech

I just bought an A10 and its workin well....I also got a BLtouch z probe and have installed it according to the video referred to in my A10 user manual...
the probe tests on power up but auto home goes to a much higher position and there are no BLtouch related menu items on the LCD display so I am stuck....

Firmware is Marlin 1.1.8 dated 12/25/2017 board is GT2560 V3.3 firmware rev: v1.1 hw:v2.9

do I need to update the firmware, if so, where do I download it....and if I need to compile, where are the config.h and advance config.h files?

Hi, I think you need this:http://www.geeetech.com/forum/download/file.php?id=5403

Thanks! I found the hex file finally and loaded it....BLtouch now working

That is great!

How can I update my A20M with the 3D Touch sensor firmware A20_V1.1.8_3d touch.hex ?

I downloaded the hex file, but how can I transfer it to the printer?

I updated rhe hex firmware file with Cura.