- Posts: 1
- Joined: Sat Mar 23, 2019 3:53 am
So i got my a10 printer and at first it worked fine. the only thing was when i pressed auto home the x axis will go to the left and will press itself against the bumper and make this horrible grinding sound which i thought was normal. dumb mistake. so now when i press auto home it goes too far to the left and its over the edge of the printer bed. so when i go to print the print is shifted left. i thinnk the x axis end stop isnt working cause there isnt a light that turns on but. i dont know anything about 3d printers so i have no idea how to fix anything. even if there is something wrong with the end stop i would have no idea how to fix it. if anyone could help that would be awesome.
- image1.jpeg (288.07 KiB) Viewed 918 times
- Posts: 9
- Joined: Thu Mar 07, 2019 7:32 am
You can check the state of your end stops with M119
. Use repetier host etc. for that. Just press and release them to make sure they work properly if not check if they are connected correctly and check continuity with a multimeter.
Anyway, auto home is supposed to go with x to the left beside the bed, but the endstop light not turning on isn't good
Who is online
Users browsing this forum: No registered users and 12 guests