G1 E100 F200;
This comand is right for A10, with one feeder extruder, but how can extrude 100 mm of filament from both extruders on A10M?
You can set the mixer for the duration of the test to split 100/0 and then 0/100.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
There is no separate Esteps/mm for left and right motor. If i move extruder 300mm, i 've got 297mm on the left and 300mm on the right side. How to solve this problem?
- lever spring force (deformations of filament)
- diameter of filament
- diemeter of "saw wheel"
I have A10M with factory preset steps unti now and my print profile is tuned to these "failed" 340 steps. If you will buy other geared extruders, there are 340 steps...
In reality with my spring force setup there are 451 steps instead of 430, just because plastic is deformed a lot...
I have an A10M, which is a pain in the neck to keep printing
I use Proterface, You can download it free.
Then you can select either E0 or E1 (they call it extruder 0 and extr 1)extruders and also the mm to feed.
Download from https://all3dp.com/2/pronterface-how-to ... set-it-up/
Who is online
Users browsing this forum: No registered users and 34 guests