Marlin 1.1.9 with & without bltouch + TMC2208

Post Reply
Matboy
Posts: 5
Joined: Sat Dec 08, 2018 6:55 am

Marlin 1.1.9 with & without bltouch + TMC2208

Post by Matboy » Sat Dec 08, 2018 6:58 am

I need help to make work my printer with the news drives TMC2208 for X,Y,Z,E0

Matboy
Posts: 5
Joined: Sat Dec 08, 2018 6:55 am

Re: Marlin 1.1.9 with & without bltouch + TMC2208

Post by Matboy » Sun Dec 09, 2018 6:38 am

Yes, I have all mounted, but I wish optimizes the firmware of somebody need I can send it

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Marlin 1.1.9 with & without bltouch + TMC2208

Post by William » Mon Dec 10, 2018 12:16 am

Matboy wrote:
Sat Dec 08, 2018 6:58 am
I need help to make work my printer with the news drives TMC2208 for X,Y,Z,E0
How is it going on?
Dose it work with your printer? :D
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Matboy
Posts: 5
Joined: Sat Dec 08, 2018 6:55 am

Re: Marlin 1.1.9 with & without bltouch + TMC2208

Post by Matboy » Tue Dec 11, 2018 5:33 am

the printer goes well and very quiet even, I had to adjust the Vref of the drivers and the steps of Extruder, now I think I lost some step on the Y axis.

Matboy
Posts: 5
Joined: Sat Dec 08, 2018 6:55 am

Re: Marlin 1.1.9 with & without bltouch + TMC2208

Post by Matboy » Tue Dec 11, 2018 11:42 pm

But think that maybe the problem is cura because I print the same piece two time and all time I get the same defect
Attachments
0A06BC0E-06B7-4A24-A6F2-0679CE6D7856.jpeg
0A06BC0E-06B7-4A24-A6F2-0679CE6D7856.jpeg (347.16 KiB) Viewed 10107 times

Matboy
Posts: 5
Joined: Sat Dec 08, 2018 6:55 am

Re: Marlin 1.1.9 with & without bltouch + TMC2208

Post by Matboy » Thu Dec 13, 2018 1:14 am

I didn’t try

User avatar
Tomyuan
Posts: 41
Joined: Thu Jan 11, 2018 3:55 pm

Re: Marlin 1.1.9 with & without bltouch + TMC2208

Post by Tomyuan » Thu Dec 13, 2018 10:18 am

You can try to use the slic3r then you can compare them :d

Post Reply