Kudos to combat341 for this
I thought that this needed to be a separate thread, rather buried in a post.
I did this and it works.
Thanks again combat341!!!!
Same problem with my new A10, with GT2560 v3.0 mainboard.
The extruder fan in not spinning, event at max (255) power.
I tested the mentioned solution with FAN_SOFT_PWM does not work.
The JP2 jumper does not seem to exist on that board (or I was not able to locate it).
Any idea ?
But proposed solution "play with the cables" like : https://www.youtube.com/watch?v=J8xEsue_Xa8
==> does not work"
Who is online
Users browsing this forum: No registered users and 13 guests