geeetech A10, motherboard GT2560 REV B DON'T WORK!

Moderator: vert

Post Reply
fruffo
Posts: 1
Joined: Fri Sep 07, 2018 7:39 pm

geeetech A10, motherboard GT2560 REV B DON'T WORK!

Post by fruffo » Sat Sep 08, 2018 8:17 pm

I have a geeetech A10,

with the motherboard GT2560 REV B

Nothing appears on the display, I tried to reload the firmware 1.0.4 with arduino ide, but the .ino never finishes loading.
Coem can I solve? do I have to reload the bootloader? how can I do? I do not know where the pins are on my card, to load it.

THANK YOU!

User avatar
MichaelK
Posts: 43
Joined: Thu Mar 22, 2018 5:20 pm
Location: Germany

Re: geeetech A10, motherboard GT2560 REV B DON'T WORK!

Post by MichaelK » Sun Sep 09, 2018 5:57 pm

Wich firmware you are using? The firmware with boot loader included? Please don't use this one!!!

Use the firmware without the boot loader.
With Arduino you need to use the correct version of the arduino -ide to flash the printer.

Onto GitHub you can found the newest version of the firmware:
https://github.com/Geeetech3D/Prusa_I3_3Dprinter A10_Marlin_1.1.8! for the A10!

Try them please. :)

zonalimitatore
Posts: 78
Joined: Tue Aug 28, 2018 7:12 am
Location: Italy

Re: geeetech A10, motherboard GT2560 REV B DON'T WORK!

Post by zonalimitatore » Sun Sep 09, 2018 7:04 pm

fruffo wrote:
Sat Sep 08, 2018 8:17 pm
I have a geeetech A10,

with the motherboard GT2560 REV B

Nothing appears on the display, I tried to reload the firmware 1.0.4 with arduino ide, but the .ino never finishes loading.
Coem can I solve? do I have to reload the bootloader? how can I do? I do not know where the pins are on my card, to load it.

THANK YOU!
Same things happen to me.
I write a guide: https://zonalimitatore.blogspot.com/201 ... rev-b.html
Tell me,when finish,if your sd reader work or not

Chub
Posts: 51
Joined: Sun Jan 13, 2019 2:35 am

Re: geeetech A10, motherboard GT2560 REV B DON'T WORK!

Post by Chub » Thu Feb 21, 2019 8:27 pm

I have the same issue on a brand new printer. Do you have the instructions in English? Looks like a great guide.

Thanks

bernte_one
Posts: 25
Joined: Fri Aug 24, 2018 4:39 pm

Re: geeetech A10, motherboard GT2560 REV B DON'T WORK!

Post by bernte_one » Thu Feb 28, 2019 5:43 pm

take the guarantee right over geeetech support

mine printer had some failures from start (first meachanical trouble and bad parts and at last of sensor/ software board problem), and if i could jump into past i would never take a geeetech again :x

Post Reply

Who is online

Users browsing this forum: No registered users and 14 guests