A10 auto level sensor

[zonalimitatore]

did you add g29 to your slicer to do auto bed levelling?

Yes,but I have no control on LCD menu,and I cannot do a Z home,cause don't detect when probe touch the bed,and continue fall down

sounds like firmware is written wrong.

I'm not the only one have this problem

[zonalimitatore]

i try that too

[zonalimitatore]

It's very hard for me know why doesn't work....I try 2 way (that posted here and thinkiverse),and both not work.
3dtouch dont give me response.

There is someone here that have a 3dtouch working on a10 rev B version 1 ?

[zonalimitatore]

A stupid question.Have i to set pin 11/13 (servo) for work?

When u are in endsop debug mode and manually pull up&down the probe,what's appening?
Repetier give u the state of pin?

[zonalimitatore]

can you try with gcode sender?
Cause,if my sensor it's defected i send back

[William]

I try to wire like in photo above.
When start the printer,the 3d touch do up&down 2 times ,and stay up with red led on.

The problem is:
I have no control on it
In the menu if i click autotest,no moves,and the same on other commands

I try to do z home,but doesn't stop,and signed my bed

It's my problem or anyone have solve it?

Could you attach the wires of the 3dtouch?

[William]

A stupid question.Have i to set pin 11/13 (servo) for work?

When u are in endsop debug mode and manually pull up&down the probe,what's appening?
Repetier give u the state of pin?

You can join the facebook group.
You can refer to the pdf for GT2560VB work with 3dtouch
https://www.facebook.com/groups/315127105604393

[jadonsancho]

i try that too

this is hard as i do not have anything to physically work with doing everything by latest kickass proxy unblocked.
i cant exactly bust out a multimeter and back trace the pins or anything.

thanksss