http://www.geeetech.com/wiki/index.php/ ... ing_Sensor
Board (GT2560 Rev B):
https://images-na.ssl-images-amazon.com ... WWixiL.jpg
There are many manuals how to do it with the "GT2560 Rev A" board. But the A10 uses the "GT2560 Rev B" one and the connectors are different.
Please help to get this done...
PS: I am looking for the sensor mount too.
https://www.youtube.com/watch?v=MlQdz1E ... gs=pl%2Cwn
These user talking about the fans, but at the video you could seen the "Autolevel-BL-Touch Sensor" onto the A10 self made.
Thats a way you can use byself??
Extension wires are needed, and the way for connection is shown as the picture below. This might need some cutting/rewiring and also patience.
At this site : http://www.geeetech.com/wiki/index.php/ ... ing_Sensor
it is signed to be connected to 5V. On your photo it is connected to Z-Max. Is that correct?
Code: Select all
Endstop connector: VCC [orange] | VCC Z_MAX [red?] | Z_MIN [white] GND [brown] | GND [black] VCC | VCC Y_MAX | Y_MIN GND | GND VCC | VCC X_MAX | X_MIN GND | GND
Who is online
Users browsing this forum: No registered users and 4 guests