Page 9 of 9

Re: Geeetech A10 firmware Marlin 1.1.9

Posted: Mon Feb 18, 2019 9:28 am
by William
CuRock wrote:
Thu Feb 14, 2019 7:33 pm
Hello there,

I've updated my A10 just bought, but now in the "board info" , the board appears as Ultimaker, when previously was GT2560 (the real board), Is it a problem??. As a noob in 3d printing, now I dont know how to reset the firmware to the beginning state. Any advice?

Thanks in advance
I think if the pins.h file is correct.
Then it won't be a problem.

Re: Geeetech A10 firmware Marlin 1.1.9

Posted: Mon Feb 18, 2019 10:19 pm
by vert
In older versions of Marlin the 2 pins files are nearly identical the gt2560 is an ultimaker clone.

Re: Geeetech A10 firmware Marlin 1.1.9

Posted: Tue Feb 19, 2019 9:15 am
by William
vert wrote:
Mon Feb 18, 2019 10:19 pm
In older versions of Marlin the 2 pins files are nearly identical the gt2560 is an ultimaker clone.
You are correct ;)

Re: Geeetech A10 firmware Marlin 1.1.9

Posted: Tue Feb 19, 2019 11:11 pm
by entretoize
There's a 1.1.9 version on marlin's github, is it the one you modified to work on A10 ?

Re: Geeetech A10 firmware Marlin 1.1.9

Posted: Wed Feb 20, 2019 9:33 am
by William
entretoize wrote:
Tue Feb 19, 2019 11:11 pm
There's a 1.1.9 version on marlin's github, is it the one you modified to work on A10 ?
I think you can download the Marlin2.x for A10.
Try to find vert's post then you can download it.

Re: Geeetech A10 firmware Marlin 1.1.9

Posted: Wed Feb 20, 2019 5:21 pm
by entretoize
William wrote:
Wed Feb 20, 2019 9:33 am
I think you can download the Marlin2.x for A10.
Try to find vert's post then you can download it.
OK, but this is again some sources from someone, and we don't know what it is based on exactly. How to start from the marlin offical code and make it work for A10 ? Is it explained somewhere ?

Re: Geeetech A10 firmware Marlin 1.1.9

Posted: Thu Feb 21, 2019 1:11 pm
by William