Geeetech

Wooow

Another novelty, new versions of controllers grow like mushrooms after the rain.

Hello everyone,
I have the software installed on my a10. Why does he start at bed levels in the middle of the heating bed and leaves out the left half of the heating bed? what are those settings for Fade Height and Bed Z? What is the setting set home offset?

So can I get an actual helpful answer


can I flash this firmware on my A10 with the gt2560 rev 6??????

1.Marlin 1.1.8 for A10 exist some problem,need to fix it at first.
2.We have got the feedback of these. When we finished it,we will release it.
We won't release it if we didn't test finished it.

Does this firmware work with the BLTOUCH?

vert wrote: ↑

Sun Dec 09, 2018 6:17 am

mine does.
http://www.geeetech.com/forum/viewtopic ... 98&t=61991

William wrote: ↑

Wed Nov 28, 2018 9:48 am

1.Marlin 1.1.8 for A10 exist some problem,need to fix it at first.
2.We have got the feedback of these. When we finished it,we will release it.
We won't release it if we didn't test finished it.

any news on this????

ebam2014 wrote: ↑

Sun Dec 09, 2018 5:53 pm

William wrote: ↑

Wed Nov 28, 2018 9:48 am

1.Marlin 1.1.8 for A10 exist some problem,need to fix it at first.
2.We have got the feedback of these. When we finished it,we will release it.
We won't release it if we didn't test finished it.

any news on this????

I think Geeetech will release the Marlin 2.x instead of Marlin 1.1.9

vert wrote: ↑

Mon Dec 10, 2018 1:51 am

William wrote: ↑

Mon Dec 10, 2018 12:00 am

ebam2014 wrote: ↑

Sun Dec 09, 2018 5:53 pm

any news on this????

I think Geeetech will release the Marlin 2.x instead of Marlin 1.1.9

i posted a copy of 2.0 semi setup for the a10 it has issues with the screen and reading e temp but it did home xyz just fine.

Good job!

Which firmware should i use for a geeetech A10 latest version? (I think it's the latest, i've bought It 1 week ago)

Next week i'll get a bltouch, should i change the firmware or just plug the bltouch?