pausing instead of z hop

[Cat of Many Faces]

Just got my A10 last week and it has a strange issue. when it should do a z hop the printer just pauses for a several seconds and makes a deep kinda thumping/thrumming sound before eventually resuming.

I'm running the standard 1.1.8 firmware. i tried changing to the most recent build of 2.0 but instead of pausing it just locks up and becomes unresponsive until restart so i reverted back to 1.1.8

i recorded a rather clumsy video, https://youtu.be/5AfZkt2pA8E but the noise seems to not have made it onto the recording.

Any idea what i'm doing wrong?

(apart from the video quality )

[William]

Hi, Does this happen when you print all the models?

[Cat of Many Faces]

Yes, it happens no matter the model being printed, just whether or not it has z hop enabled when sliced.

I tried the exact same model sliced without z hop and it had no problems printing.

I'm using Cura 4.1 for my slicer

[jjjji]

Creo que el otro día leí que el cura 4.1 tiene un fallo en el zhop podrias provar otra versión a ver que tal

[Cat of Many Faces]

Thanks jjjji, that's probably the issue. i'll try the solution i found and update if that fixes it

[Cat of Many Faces]

it worked! Thank you so much! i just had to tell cura a maximum z speed.