Geeetech

Hi All i am new to the 3d printing world and have purchased a A10M printer all seems to be going ok and this forum is helping immensley with issues I am having, the current issue I have is around the wifi module

I do not have any internet other than what I tether from my mobile phone and thought this would work with the wifi module to send prints directly to the printer but I cannot figure out what the router and password are from my phone. I can connect to wifi module but do not know where or if it is possible to use mobile as router as well. . . . . . any help would be much appreciated. My phone is xaiomi redmi 6

Hello.


I think it'll be possible to do that.
However, this possibility will be determined by the version of the smartphone operating system.

Try to find Threading and access point options in the settings.
Next, check what settings you have to make.
On my smartphone I can enable Hotspot WLAN option.

Will have another look thanks for reply

_kaktus_ wrote: ↑

Sat Apr 13, 2019 3:39 pm

Hello.


I think it'll be possible to do that.
However, this possibility will be determined by the version of the smartphone operating system.

Try to find Threading and access point options in the settings.
Next, check what settings you have to make.
On my smartphone I can enable Hotspot WLAN option.

Thank you man. I was looking for this too

Could you print the module?