Mac - 10.14.3 and printer i3 ProW 3D with 340C chip
Posted: Sun Mar 03, 2019 7:40 pm
I need help.
Running - Mac Mojave 10.14.3
Printer - i3 ProW 3D 340c Chip
I have...
Downloaded installed FTDIUSBSerialDriverv2.4.2
Repetier - Host Mac1.2.0
The I opened and Repetier and - printer settings - connection - (two appear when usb connected) usbserial-1420 and wchusbserial1420.
but at the bottom it shows commands waiting and 1249FPS Unknown printer firmware... (but the number can change with every click -630,1291.1116,967.1338,1184)
Downloaded and installed Arduino 1.0.1 and 1.8.7 opened and ran.
If someone can advise how i connect Mac to printer... then which correct software and in order of loading and what I should expect to see on the green LCD... I then still have to calibrate and print something.
If anyone can help I would be grateful
Running - Mac Mojave 10.14.3
Printer - i3 ProW 3D 340c Chip
I have...
Downloaded installed FTDIUSBSerialDriverv2.4.2
Repetier - Host Mac1.2.0
The I opened and Repetier and - printer settings - connection - (two appear when usb connected) usbserial-1420 and wchusbserial1420.
but at the bottom it shows commands waiting and 1249FPS Unknown printer firmware... (but the number can change with every click -630,1291.1116,967.1338,1184)
Downloaded and installed Arduino 1.0.1 and 1.8.7 opened and ran.
If someone can advise how i connect Mac to printer... then which correct software and in order of loading and what I should expect to see on the green LCD... I then still have to calibrate and print something.
If anyone can help I would be grateful