Bed is not flat, what are the options?

Post Reply
redirect303
Posts: 16
Joined: Sat Jun 29, 2019 2:34 am

Bed is not flat, what are the options?

Post by redirect303 » Tue Jul 02, 2019 2:11 am

My MeCreator2 is new - arrived yesterday.

When leveling the bed, I noticed that the bed is a bit bulged in the center compared to the corners. There is about 0.5mm raise in the center. I am not sure if this is within the accepted parameters, or the bed requires change.

Just to clarify: MeCreator2 bed is Aluminum with heater PCB.

Thanks.

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Bed is not flat, what are the options?

Post by William » Tue Jul 02, 2019 9:25 am

Hi, you can try removing the hot bed to see if the hot bed is flat. If the bump is uneven, you can contact your sales to replace it.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply