Printer Hot Bed

Post Reply
503 Printer Guy
Posts: 1
Joined: Sun Dec 02, 2018 2:54 am

Printer Hot Bed

Post by 503 Printer Guy » Sun Dec 02, 2018 3:00 am

I have a MeCreator 2 and it appears to have a bend in the printer bed gantry. I have to have the center middle screw so tight that there is no spring in it. Where the front 2 are almost unscrewed and i still can not get the bed level. when I put a level on the gantry it shows that it goes down hill from rear of the printer to the front of the printer. Which make sense with the way the screws are set. Any one have any suggestion on how to level this printer bed?

Thanks

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest