MeCreator2 for Slic3r Prusa Edition

Post Reply
ejo
Posts: 6
Joined: Sun Apr 09, 2017 9:11 pm

MeCreator2 for Slic3r Prusa Edition

Post by ejo » Tue May 15, 2018 8:09 pm

If someone else wants to experiment with Slic3r, here is my setting file. I often tweak something for each print, but this is pretty good base configuration.

Usage:
1) Unzip (this forum didn't allow me to attach .ini file)
2) Import MeCreator2.ini to Slic3r PE:
File -> Load Config Bundle

Made with this version:
https://github.com/prusa3d/Slic3r/relea ... ion_1.39.2

*Updated v2:
-Correct g-code to turn off bed after print. It was originally ok, but I must had made mistake during cleanup before sharing.
-Support settings that should generate removable supports, if enabled.
Attachments
MeCreator2_v2.zip
(1.75 KiB) Downloaded 643 times
Last edited by ejo on Wed May 16, 2018 8:02 pm, edited 1 time in total.

Gingko
Site Admin
Posts: 230
Joined: Tue Apr 24, 2018 10:43 am

Re: MeCreator2 for Slic3r Prusa Edition

Post by Gingko » Wed May 16, 2018 11:31 am

Thank you for sharing! :D

ejo
Posts: 6
Joined: Sun Apr 09, 2017 9:11 pm

Re: MeCreator2 for Slic3r Prusa Edition

Post by ejo » Wed May 16, 2018 8:04 pm

I updated the settings to include good supports (if enabled) and to turn off bed after print (I had accidently changed wrong gcode).

Because it is opening post in topic, it went again under review. So please wait if it is not visible.

Post Reply