Okay folks so I have managed to update my firmware after finding a hex version on the geetech website and using cura to update.
My problem is the z axis is moving in the wrong direction and I cannot use arduino/marlin to change the direction (1.0.1) does not work on 64 bit mac osx.
Does anyone know of any solution to this???
TIA
Woo
Z direction wrong
Re: Z direction wrong
Hi!
You can try to swap the Z-axis driver with the Y or X-axis driver, and test it again. It may be a driver failure, you can replace the driver.
You can try to swap the Z-axis driver with the Y or X-axis driver, and test it again. It may be a driver failure, you can replace the driver.
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: Z direction wrong
Hi, you can try these methods:
1)Check the wires of the endstop.
2)You need to check the endstop work or not
http://geeetech.com/forum/viewtopic.php?f=17&t=60927
3)Swap the a4988 driver.This might work
1)Check the wires of the endstop.
2)You need to check the endstop work or not
http://geeetech.com/forum/viewtopic.php?f=17&t=60927
3)Swap the a4988 driver.This might work
-Keep your mind and try to test it.
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!