Printed Vase.stl file looks a bit strange

Post Reply
JuergenL
Posts: 2
Joined: Sat Feb 15, 2020 6:21 pm

Printed Vase.stl file looks a bit strange

Post by JuergenL » Sat Feb 15, 2020 6:42 pm

Hello,

I got a Prusa I3 Pro W and it was a nice job to assemble it. After everything seemed to be well done I printed the job vase.stl with the default settings. The software is EasyPrint 3D Version 1.2.6 and Firmware is V1.0.05.

The result looks a bit strange, the surface is not dense and compact but it is looking more open like a mesh grid. Is this how it should look like or what parameters can I set to improve the outcome?

Thanks a lot for your help.

Best regards, JuergenL
Image
Attachments
DSC_0247.JPG
DSC_0247.JPG (233.92 KiB) Viewed 6519 times

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Printed Vase.stl file looks a bit strange

Post by William » Sun Feb 16, 2020 9:25 am

Hi,you can set the print speed to 30mm / s
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

JuergenL
Posts: 2
Joined: Sat Feb 15, 2020 6:21 pm

Re: Printed Vase.stl file looks a bit strange

Post by JuergenL » Tue Feb 18, 2020 5:47 pm

Hello William,
thank you very much for your immediate reply, but in the "Slicing Settings"-Tab there is no general "print speed" available, but all these (see picture).
Could you please again have a look and precise which of these I have to change?
Thanks again a lot.
Attachments
Slicing_Settings.JPG
Slicing_Settings.JPG (50.23 KiB) Viewed 6473 times

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Printed Vase.stl file looks a bit strange

Post by William » Wed Feb 19, 2020 9:19 am

Hi,regarding your printing temperature, it needs to be adjusted to about 200 °
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Zoulouz
Posts: 10
Joined: Thu Dec 26, 2019 9:44 pm

Re: Printed Vase.stl file looks a bit strange

Post by Zoulouz » Sat Feb 22, 2020 1:19 am

Sous-extrusion qui peut être due à de multiples facteurs .. ?

Post Reply