GT2560 A+: Marlin 1.1.9 with BLTouch and TMC2208

Post Reply
etwasmitbaum
Posts: 2
Joined: Fri May 24, 2019 10:16 pm

GT2560 A+: Marlin 1.1.9 with BLTouch and TMC2208

Post by etwasmitbaum » Fri May 24, 2019 10:29 pm

Hello,
i have installed the TMC2208 on my GT2560 Rev A+ and want to update to the newest Marlin Firmware (1.1.9).
My problem is structure of Marlin has change i do not know where and how to set the correct pins and settings for BLTouch and the TMC2208.

Can someone tell exactly how to configure Marlin 1.1.9 for my I3 Pro W with the GT2560 A+ board and working BLTouch and TMC2208 (StealthChop mode)?
It would be better if someone upload the finished firmware.

User avatar
William
Site Admin
Posts: 4614
Joined: Tue Jun 07, 2016 9:38 am

Re: GT2560 A+: Marlin 1.1.9 with BLTouch and TMC2208

Post by William » Sat May 25, 2019 11:41 am

Hi, you can refer to this for review, I hope this will help you:http://www.geeetech.com/forum/viewtopic ... 66&t=68258
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

etwasmitbaum
Posts: 2
Joined: Fri May 24, 2019 10:16 pm

Re: GT2560 A+: Marlin 1.1.9 with BLTouch and TMC2208

Post by etwasmitbaum » Sun May 26, 2019 4:43 am

Thank you!
Everything is working fine!

Thank you again!!!

User avatar
William
Site Admin
Posts: 4614
Joined: Tue Jun 07, 2016 9:38 am

Re: GT2560 A+: Marlin 1.1.9 with BLTouch and TMC2208

Post by William » Mon May 27, 2019 9:13 am

Sound good :D
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest