i3 Pro W and BLTouch / 3Dtouch issue

User avatar
Site Admin
Posts: 4938
Joined: Tue Jun 07, 2016 9:38 am

Re: i3 Pro W and BLTouch / 3Dtouch issue

Post by William » Sun Apr 07, 2019 6:35 pm

I think you should use the UBL mode for the auto level.
You can try to upload the firmware of Marlin 1.1.8 for PROB.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

User avatar
Site Admin
Posts: 888
Joined: Wed Nov 21, 2018 3:50 pm
Location: Marlin Developer

Re: i3 Pro W and BLTouch / 3Dtouch issue

Post by vert » Thu May 09, 2019 5:23 pm

awestom wrote:
Fri Apr 05, 2019 5:19 am
I found this thread: https://www.geeetech.com/forum/viewtopi ... 82&t=61259
Which has a different version of Configuration.h, I compared it to the Configuration.h that came with the "I3 ProW GT2560A+ with 3dtouch.zip" firmware, however it was vastly different, it looks like it's from a different version of Marlin, do I just swap the Configuration.h files and re-flash? I'm worried that mixing files from different firmwares may brick my board.

I also heard about undoing the screw in the BLTouch until the light went off, and then re-tightening it until the light just came on, I tried undoing the screw and it came out before the light went off, so I put it back and tightened it to how I found it.
mixing configs from other version of marlin it generally just wont compile its best to convert them over or modify existing.
Marlin 2.0 For Geeetech 3D Printers
My YouTube
My GitHub
My thingiverse
My Discord
The 3Dprinting hobby isn't a door you open, it's a path you walk as you learn.\
Being hostile is the best way to not get assistance.
True knowledge is being able to teach others.

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests