Initial Configuration

Post Reply
awestom
Posts: 13
Joined: Sun Mar 17, 2019 1:00 pm

Initial Configuration

Post by awestom » Sun Mar 17, 2019 1:03 pm

Hi all,

I'm having a lot of trouble with my initial configuration. The X and Y homing is working fine, however the Z homing is not.
I disabled the stepper motors, and then lowered the extruder, set the bed height, then when I pressed "up" in Cura, it went up, but it never went back down. When I click the 'Home' button for Z, it just goes and crashes into the top.
Anyhelp would be amazing right now.

awestom
Posts: 13
Joined: Sun Mar 17, 2019 1:00 pm

Re: Initial Configuration

Post by awestom » Sun Mar 17, 2019 3:02 pm

Everytime I click home, it homes X properly, it homes Y properly, then it goes up by about 5mm on the Z axis, over and over.

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Initial Configuration

Post by William » Mon Mar 18, 2019 2:30 pm

Pls check the FAQ of i3 type printer at first.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

awestom
Posts: 13
Joined: Sun Mar 17, 2019 1:00 pm

Re: Initial Configuration

Post by awestom » Tue Mar 19, 2019 5:00 am

Turns out I had the Z end stop plugged into the "Min End" plug on the motherboard, instead of the "Max End".

Post Reply