Very disappointed

Post Reply
Jimbob
Posts: 1
Joined: Sun Dec 23, 2018 7:59 pm

Very disappointed

Post by Jimbob » Sun Dec 23, 2018 8:08 pm

Built my Prussia i3 pro w the power would come on but it wouldn't do any commands and the power supply on the side was making a funny clicking noise then it blew a fuse so how do I go about getting a new power supply

User avatar
_kaktus_
Site Admin
Posts: 1260
Joined: Fri Dec 15, 2017 10:06 pm
Location: PL
Contact:

Re: Very disappointed

Post by _kaktus_ » Sun Dec 23, 2018 9:18 pm

Hello.
:mrgreen:

If it happened with the load connected, it is a bad sign.
There are two reasons for this:
  • Installation error,
  • factory defect of the PSU.
It is worth to verify the cause of the defect so that such a situation does not occur again after replacing the PSU.

To replace the power supply with a new working one, please contact your salesperson. ;)
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.

Post Reply