Page 1 of 1

Some of my prints on the Pro W

Posted: Mon Oct 01, 2018 8:53 pm
by keyser187
just thought i would share some of my prints i have done on my Pro W and hopefully encourage peeps not to give up on it.
my printer is not perfectly calibrated or fine tuned, also not the best cooling fan but still pleased with the results.

Re: Some of my prints on the Pro W

Posted: Tue Oct 02, 2018 1:17 am
by _kaktus_
Hi
:mrgreen:

Super printouts. :D
Some of them are very difficult to make.

Congratulations. :lol:

Re: Some of my prints on the Pro W

Posted: Tue Oct 02, 2018 2:47 am
by keyser187
thanks.
the t rex was my last print, had to be in transparent because thats all i got :( and that was done in two pieces with NO SUPPORTS!!!
i love models with no supports! :D

Re: Some of my prints on the Pro W

Posted: Mon Feb 11, 2019 8:20 pm
by kokorski
Hi guys:

Very nice job. Can you tell me what software are you using....
Can you share your profile if its possible?
Thx in advance

Re: Some of my prints on the Pro W

Posted: Mon Feb 11, 2019 8:49 pm
by BR365
The t rex looks incredible! Great print!

Re: Some of my prints on the Pro W

Posted: Wed Feb 20, 2019 1:11 am
by joe88
Hi,

very nice prints!

I'm finished my assembly of the printer and i have now some issues with the extruder but I am not sure if this is on hardware side or just the settings.

Can you provide my youre settings please?

Regards

Re: Some of my prints on the Pro W

Posted: Wed Mar 27, 2019 11:03 pm
by keyser187
im using cura for slicing.
profiles and settings will change depending on the model and the material being used and also individual printers so copying settings and profiles dont really work.

Re: Some of my prints on the Pro W

Posted: Thu May 23, 2019 5:47 am
by manuolito
Hi keyser187,

Those are a handful of great prints, congratulations. You seem to be experienced with 3D printer. Aside sharing the profiles which as you mentioned are too specific, do you have some tips? Specially for the support part? Indeed, did you managed to get the Mario without support?

Also, did you upgraded your printer? I can see a fan in a position which is not the initial one (at least in my i3 Pro W version from April 2019).

Thanks :D

Re: Some of my prints on the Pro W

Posted: Mon Aug 19, 2019 5:46 pm
by bucito76
Wowwwww , amazing impressions. A real show. I would like to know if the firmware you use is the original one, I can't find updates.

greetings and congratulations