Manual Movement does not work

Post Reply
chhe
Posts: 0
Joined: Wed Mar 21, 2018 1:48 am

Manual Movement does not work

Post by chhe » Wed Mar 21, 2018 1:52 am

Hello,

I just assembled my Prusa i3 W. If I control the Axis via the display it all works fine. Move home does work fine, too.

But if I want to control it manually it does not work in EasyPrint 3D.

What is the issue?


Thank you!

wthile
Posts: 0
Joined: Sat Mar 10, 2018 3:36 am

Re: Manual Movement does not work

Post by wthile » Wed Mar 21, 2018 11:03 pm

in easyprint 3d the make sure you have the right com port and check the buad rate. Mine was set to 256000 and it should be 250000 at 256000 mine would not move either.

richardradford
Posts: 0
Joined: Mon Mar 26, 2018 3:30 am

Re: Manual Movement does not work

Post by richardradford » Tue Apr 03, 2018 12:07 am

I gave up with EasyPrint as it wouldn't communicate properly (as soon as it connected the bottom line of LCD display showed random junk characters).

Installed Repetier-Host and have full control.

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests