Probably not to be conquered.
Our model has not been supported for several years.
The alternative is any other controller board and 32bit Marlin firmware.
But you have a lot of work to do.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Who is online
Users browsing this forum: No registered users and 24 guests