Post
by _kaktus_ » Tue Oct 01, 2019 2:38 am
Hello Ken.
In your case, he proposes two things:
- check if the bowden tube is pushed down to the very end of the throat (it must be evenly cut),
- conduct a test in which you will use the black filament in both extruders
and then another white one.
For easy control, draw a line at equal intervals on each filament.
I can guess that the filament used is causing problems.
Your test will show if I am right.
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.