M201 Extruder not working properly

Moderator: _kaktus_

Post Reply
User avatar
_kaktus_
Site Admin
Posts: 1258
Joined: Fri Dec 15, 2017 10:06 pm
Location: PL
Contact:

Re: M201 Extruder not working properly

Post by _kaktus_ » Tue Oct 01, 2019 2:38 am

Hello Ken.
:mrgreen:

In your case, he proposes two things:
  1. check if the bowden tube is pushed down to the very end of the throat (it must be evenly cut),
  2. conduct a test in which you will use the black filament in both extruders
    and then another white one.
For easy control, draw a line at equal intervals on each filament.
:D

I can guess that the filament used is causing problems.

Your test will show if I am right. :lol:
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.

Post Reply

Who is online

Users browsing this forum: No registered users and 14 guests