Another edition of the M201 printer firmware for the GTM32Pro vB controller board.

Moderator: _kaktus_

Post Reply
User avatar
_kaktus_
Site Admin
Posts: 1258
Joined: Fri Dec 15, 2017 10:06 pm
Location: PL
Contact:

Another edition of the M201 printer firmware for the GTM32Pro vB controller board.

Post by _kaktus_ » Wed Jun 19, 2019 11:33 pm

Hi all.
:mrgreen:

I will not wait any longer and give the users another version of the firmware for our printer model. :D

I was supposed to make the firmware available only after thorough testing. However, there is still no time. :?
So I release it earlier. Unfortunately, I am not able to say what changes have been made. The team that was responsible for the development for a long time no longer works for GT. I hope that more than just the version number label has changed. :lol:
What I want and what I want for you. ;)
.
gtm32_machine_m201_V1.0.04.zip
(62.24 KiB) Downloaded 204 times
I've uploaded the firmware to my printer. It was also done by my friend from France (algernon).
The printers are still working. :lol:
.
firmware1-0-04.jpg
firmware1-0-04.jpg (343.75 KiB) Viewed 6598 times
.
Once you have uploaded the new firmware, don't forget to enter the used settings again. Then it is worth to save them in the memory of the controller. :!:
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.

User avatar
William
Site Admin
Posts: 6330
Joined: Tue Jun 07, 2016 9:38 am

Re: Another edition of the M201 printer firmware for the GTM32Pro vB controller board.

Post by William » Thu Jun 20, 2019 9:35 am

Thanks for your feedback.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

User avatar
_kaktus_
Site Admin
Posts: 1258
Joined: Fri Dec 15, 2017 10:06 pm
Location: PL
Contact:

Re: Another edition of the M201 printer firmware for the GTM32Pro vB controller board.

Post by _kaktus_ » Thu Jun 20, 2019 11:49 am

;)
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.

Post Reply

Who is online

Users browsing this forum: No registered users and 20 guests