experience sharing

Moderator: _kaktus_

Post Reply
algernon
Posts: 12
Joined: Mon Oct 30, 2017 2:48 pm

experience sharing

Post by algernon » Thu Jan 17, 2019 3:46 am

hello, looking for contacts to share experience of the I3 M201
(modifications, parameters, G-code,Stl, problems, remedies,...)
Last edited by algernon on Sat Jan 19, 2019 9:04 pm, edited 1 time in total.

User avatar
_kaktus_
Site Admin
Posts: 1255
Joined: Fri Dec 15, 2017 10:06 pm
Location: PL
Contact:

Re: experience sharing

Post by _kaktus_ » Thu Jan 17, 2019 11:45 pm

:D

There are already two of us. ;)
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.

algernon
Posts: 12
Joined: Mon Oct 30, 2017 2:48 pm

Re: experience sharing

Post by algernon » Fri Jan 18, 2019 3:55 pm

and already a lot of shared information 8-)

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest