Post
by _kaktus_ » Sat Aug 25, 2018 12:16 am
Hi
If you are currently building your printer or upgrading, the picture below may be helpful to you.
It shows how the Z axis motors are connected. And the order in which the cables are laid in the motor connector and controller board connector.
The other motors have the same wiring arrangement in the connectors.
- połączenia_silników_osi_Z.jpg (314.63 KiB) Viewed 4504 times
This connection guarantees the proper operation of the stepper motors.
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
