Flashing STM32 via serial line on Linux.

Post Reply
User avatar
_kaktus_
Site Admin
Posts: 1260
Joined: Fri Dec 15, 2017 10:06 pm
Location: PL
Contact:

Flashing STM32 via serial line on Linux.

Post by _kaktus_ » Tue Jul 10, 2018 2:33 am

Hi
:mrgreen:

With colleague makerenzed in mind, I present the following solution. :D

This guide is one of many, but few of them have raised my trust. This is undoubtedly one of them. :D
However, I did not test it.

The first person to try this rule, I ask for your opinion.

There is also a version for the lazy.

:mrgreen:
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.

Gingko
Site Admin
Posts: 230
Joined: Tue Apr 24, 2018 10:43 am

Re: Flashing STM32 via serial line on Linux.

Post by Gingko » Tue Jul 10, 2018 6:11 pm

Great :!: :D

User avatar
_kaktus_
Site Admin
Posts: 1260
Joined: Fri Dec 15, 2017 10:06 pm
Location: PL
Contact:

Re: Flashing STM32 via serial line on Linux.

Post by _kaktus_ » Tue Jul 10, 2018 10:55 pm

:mrgreen:
Have you already tested it?
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.

User avatar
_kaktus_
Site Admin
Posts: 1260
Joined: Fri Dec 15, 2017 10:06 pm
Location: PL
Contact:

Re: Flashing STM32 via serial line on Linux.

Post by _kaktus_ » Sun Aug 05, 2018 5:18 pm

Code: Select all

kaktus@donica:~$ aptitude search stm32
i  stm32flash                                                  - STM32 chip flashing utility using a serial bootloader 
:D
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.

Post Reply