Geeetech

Hello,
I'm looking for profiles for the A20M to be used with Repetier Host and the Slic3r software.

The print of the test Dog is quite well but my own parts I tested were underextruded. So I increased extrudion to 120% and later to 150%, but it didn't help.

Or should I try a slower speed?

Is there a Config Bundle available for Slic3r?

Moritz

Maybe mine's is not perfect.
But you can have a try:

Does the extruder working temperature achieve Preset temperature？

William wrote: ↑

Thu Apr 25, 2019 9:36 am

Does the extruder working temperature achieve Preset temperature？

Hello William,
I don't have a thermometer, therefore, I didn't check this. The Dog was printed with 205°C:



This looks very good, I think.

See Discussion here: http://www.geeetech.com/forum/viewtopic ... 08&t=68468

Thanks,
Moritz

Tomyuan wrote: ↑

Thu Apr 25, 2019 9:24 am

Maybe mine's is not perfect.
But you can have a try:
Geeetech A20M.zip

This one is for ABS, isn't it?

Maybe interesting would be the E-Step value of Your setup. Maybe, my value isn't perfect. I didn't check yet.

Greetings
Moritz

Hi,BR365


I am using the PETG for my A20M.
You can change the temp of the bed+temp of the hotend.
Then the others settings same as my PLA setting

Tomyuan wrote: ↑

Thu Apr 25, 2019 1:42 pm

Hi,BR365


I am using the PETG for my A20M.
You can change the temp of the bed+temp of the hotend.
Then the others settings same as my PLA setting

Thanks,
and could You tell me Your value for Esteps/mm?

Moritz

If you want to calibrate your estep.
Refer to this vid：
https://www.youtube.com/watch?v=X3A9Ir2SreI

My estep is 457

Tomyuan wrote: ↑

Thu Apr 25, 2019 1:57 pm

If you want to calibrate your estep.
Refer to this vid：
https://www.youtube.com/watch?v=X3A9Ir2SreI

My estep is 457

Thanks, I will check.

My current value is 340, AFAIK.

Hi Vert,
I guess, the only possible solution is to remove these disks.
E-Steps changed to 422 (Calibration done), ...

No new result depending the stringing.