Z axis motors moving in opposite direction to each other!!!

Post Reply
Anurakclark
Posts: 5
Joined: Fri Oct 11, 2019 7:42 pm

Z axis motors moving in opposite direction to each other!!!

Post by Anurakclark » Fri Oct 11, 2019 7:43 pm

Hi guys,

Just in the process of setting up the printer, ive got to the stage the test the homing positions and have encountered a problem.

Ive tried searching, but having seen any posts on my issue.

When using Repetier, connecting to the printer and commencing the manual home, the x and y axis work fine. They hit the end stop and the test progresses to the next motor test. The last stage, the z axis motors turn in the opposite direction to each other. Left side is .reverse phone lookupnba reddit pcpartpicker



When adjusting the firmware (True/false) this just switches the issue, left side goes down and right side goes up.

Is this just a simple wiring issue? have I plugged into the wrong point on the board? The board is GT2560

Thanks in advance for any help and advice anyone can offer
Last edited by Anurakclark on Tue Dec 10, 2019 4:39 am, edited 2 times in total.

GAQ
Posts: 101
Joined: Mon Jan 08, 2018 9:10 pm
Location: Manchester UK
Contact:

Re: Z axis motors moving in opposite direction to each other!!!

Post by GAQ » Fri Oct 11, 2019 8:58 pm

Hi,
I've heard of this problem before...
One builder had a circuit board with an incorrectly mounted socket...
It can be solved.
This post thread may help you...
https://www.geeetech.com/forum/viewtopi ... 996#p98996
Gerry

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Z axis motors moving in opposite direction to each other!!!

Post by William » Sat Oct 12, 2019 9:11 am

Hi,You can check if your wiring is correct.
you can refer to this:
A+接线板.jpg
A+接线板.jpg (598.18 KiB) Viewed 4459 times
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply