error nozzle 0-temp the heating element is out of order
-
- Posts: 54
- Joined: Mon Aug 27, 2018 5:08 pm
error nozzle 0-temp the heating element is out of order
Hello, I have change my Hotend, but my nozzle temp sensor give me - 19°C on my screen, I have change my Hotend and motherboard. I do not know what it can be :/
Re: error nozzle 0-temp the heating element is out of order
When you get this message ?
-
- Posts: 54
- Joined: Mon Aug 27, 2018 5:08 pm
Re: error nozzle 0-temp the heating element is out of order
I have the error when I have heat my nozzle, but mes temp is -19°c it s the problem.
Re: error nozzle 0-temp the heating element is out of order
Did u choosae the right voltage for your new hotend?
Re: error nozzle 0-temp the heating element is out of order
-19c is the default when the thermistor is not connected. You either have a broken thermistor, a broken wire from the thermistor, a bad connection on the motherboard, or a bad motherboard.
Based on the fact that you replaced the hot end, i would almost guarantee that the problem is a broken wire on the thermistor. Its very common to break the small wires when replacing the hot end.
Based on the fact that you replaced the hot end, i would almost guarantee that the problem is a broken wire on the thermistor. Its very common to break the small wires when replacing the hot end.
-
- Posts: 54
- Joined: Mon Aug 27, 2018 5:08 pm
Re: error nozzle 0-temp the heating element is out of order
Excuse me for its response time, the thermistor works on another printer, and a new thermistor does not work on the Geeetech, I just changed also extend card
Re: error nozzle 0-temp the heating element is out of order
If the thermistor works properly and the wiring is not damaged, then sadly it sounds like you have a defective controller board. I would recommend contacting your seller for a replacement.
-
- Posts: 54
- Joined: Mon Aug 27, 2018 5:08 pm
Re: error nozzle 0-temp the heating element is out of order
This problem is resolve. Now the printer does pauses during my print. I go do a new post for my new problem, thank you.
Re: error nozzle 0-temp the heating element is out of order
How did you fix problem?
Re: error nozzle 0-temp the heating element is out of order
Hi,
i tried the first time printing with ABS with 105°C at the heatbed and 230°C at the Nozzle. When heating up to temperatur, as the heatbed reaches 72°. the "error nozzle 0-temp the heating element ist out of order" pops up. The Nozzle warming up was not started
Geeetech A30
Hardware Version 3.3
Firmware V1.37.58
Heatbed failure ?
Controller failure ?
Any fixes of that problem ?
i tried the first time printing with ABS with 105°C at the heatbed and 230°C at the Nozzle. When heating up to temperatur, as the heatbed reaches 72°. the "error nozzle 0-temp the heating element ist out of order" pops up. The Nozzle warming up was not started
Geeetech A30
Hardware Version 3.3
Firmware V1.37.58
Heatbed failure ?
Controller failure ?
Any fixes of that problem ?