How to complete set up e180

Post Reply
ivanmemento
Posts: 1
Joined: Fri Dec 07, 2018 2:20 am

How to complete set up e180

Post by ivanmemento » Fri Dec 07, 2018 2:28 am

Hello, with e180 normally you can set up a lot of standard parameters with any kind of software included easyprint, but for setting up stepping motor and extruder and other special values, you must use smarttoo motor software, but many times it crashes or it doesn't recognize other values, is it possible to use different software or do you have any suggestion for tipical problem of printing: here some example

the circle in printing are not precise but oval or elliptical
the printing extrusion is too much and you get the "web effect"
the printing extrusion is too much and you get the lines too much visible or blowing out from the printed object
the y or x axes do some strange sound when it moves fast it is like it jump
the hpid is not well settled
the printing bed value are incorrect
how to install correctly touch sensor autolevelling

if you can answere to one of this situation please help
best regards to all!

Post Reply