E180 firmware bug

Post Reply
Shuflie
Posts: 9
Joined: Sun Feb 18, 2018 10:25 pm

E180 firmware bug

Post by Shuflie » Sun Sep 09, 2018 5:03 am

Discovered a bug in V1.32.41 while trying to improve quality of benchie printing. The chimney is very messy as the fan doesn't cool enough so I used Cura to specify a minimum layer time which it does by inserting G4 P commands. These just seem to crash the printer and it sits oozing fliamnet until power is removed. I tried manually changing the G4 P commands to G4 S incase it was having problems dealing with milliseconds, e.g. I changed G4 P7312 to G4 S7 but it didn't help and gave the same response. Are G4 commands working for anyone else?

Post Reply