E180 Slic3r Profile Anyone ?

Post Reply
BennyBoyW
Posts: 27
Joined: Wed Jan 24, 2018 7:40 pm

E180 Slic3r Profile Anyone ?

Post by BennyBoyW » Sun Aug 26, 2018 12:38 am

Hi All
My E180 appears to be coming on in leaps and bounds.
One thing though - I would like to switch over to Slic3r as opposed to EasyPrint.
I believe I have set up my profile correctly, but stand to be corrected.
The problem is that the printer heats up the nozzle nicely - then beeps 3 times, beeps 3 times again and then homes itself as though it's finished printing. Then the firmware seems to go a bit odd and I have to turn off and on again.
Any ideas anyone ? I've attached my profile as it stands
IniFiles.zip
(2.55 KiB) Downloaded 632 times

kyoday
Posts: 1
Joined: Wed Jul 17, 2019 3:08 pm

Re: E180 Slic3r Profile Anyone ?

Post by kyoday » Thu Jul 18, 2019 4:29 pm

hi, you solved ?

D-a-n
Posts: 2
Joined: Wed Nov 06, 2019 4:58 pm

Re: E180 Slic3r Profile Anyone ?

Post by D-a-n » Wed Nov 06, 2019 5:03 pm

Hello!

My working config for Slic3r-1.3.0.64bit
E180_NEW_CONF.zip
(1.64 KiB) Downloaded 714 times
Configured:
- optimal sticking of the part to the tape
- optimal settings for PLA
- optimal layers and part quality
- optimal print speed (medium)
- fill patter Honeycomb (recommend Rectilinear)

Not included:
Spiral vase - set if you want to print a vase, may require additional layers

Print finished G-code through EasyPrint3D!

This instruction and trial and error method helped me:
https://3deshnik.ru/blogs/vestas/slic3r ... ichja-nora

Post Reply