Hi, Are you referring to the bearing being stuck? You can lubricate it with proper lubrication.
Problems I am having with the E180
Re: Problems I am having with the E180
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: Problems I am having with the E180
The original PSU is able to manage a small heated bed...
I mod the e180 to another board, since smartoo src are useless and could mod the fw from the A30 to the E180 with heated bed, so I went for the skr1.3.
Now is printing even ABS at 90ºC heated bed, and 240ºC nozzle, with the stock psu.
https://www.thingiverse.com/thing:3680288
https://thingiverse-production-new.s3.a ... 653954.jpg
I mod the e180 to another board, since smartoo src are useless and could mod the fw from the A30 to the E180 with heated bed, so I went for the skr1.3.
Now is printing even ABS at 90ºC heated bed, and 240ºC nozzle, with the stock psu.
https://www.thingiverse.com/thing:3680288
https://thingiverse-production-new.s3.a ... 653954.jpg
Re: Problems I am having with the E180
Hello, I am having a problem printing with my geetech e180. The problem is that when I print any piece it sticks too strongly to the base and when I try to stick it out the piece breaks. I´ve been looking for this problem on the internet but I haven´t found any soulution, do you have any idea for solving my problem?
Re: Problems I am having with the E180
Hi, you can try to post textured paper,
Heat when removing the model and then remove the model with a shovel.
Heat when removing the model and then remove the model with a shovel.
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: Problems I am having with the E180
i dont know if this has been addressed anywhere else, but i just got this printer but the bed has a very bad lateral wobble that makes it impossible to print anything. its like the rollers arent tight to the frame.
is there a fix for this?
is there a fix for this?