How-To Replace Belt on X-Axis on Mecreator

Post Reply
gamura
Posts: 18
Joined: Fri Jun 23, 2017 7:11 am

How-To Replace Belt on X-Axis on Mecreator

Post by gamura » Thu Jun 29, 2017 6:12 pm

Hi,

just recently the timing belt for the x axis broke down on my mecreator2. Sadly i havent found any good tutorial on how i can fix this or even better replace the whole belt. Can you provide some kind of tutorial on your wiki or even a youtube video which can guide me through the process?

Best Regards,

Gamura

redirect303
Posts: 16
Joined: Sat Jun 29, 2019 2:34 am

Re: How-To Replace Belt on X-Axis on Mecreator

Post by redirect303 » Sat Jul 06, 2019 3:04 am

Indeed some instructions would be useful for replacing the X-axis belt on MeCreator2.

From what I could see, the belt is fastened under the carriage with some plates and screws from atop. I assume the entire extruder assy has to be removed in order to tamper with the belt.

Also, there doesn't seem to be any tension method for the X-belt...

If any admin reads this, would be appreciated to have a bit of tutorial on this one.

Thanks

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: How-To Replace Belt on X-Axis on Mecreator

Post by William » Sat Jul 06, 2019 9:20 am

Hi, thanks for your feedback.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply