Re: Mini G2S Extruders not extruding

jamest · Post by **jamest** » Thu Sep 17, 2015 1:03 pm

lol figured out way I was not getting any pla out of hot end & why pla is oozing from hot end.... both of my hot ends have no holes for pla to extrude from...lol
was I to drill out holes? ... do I need new hot ends? one has pla oozed out from every seem but not out of end.. due to no hole to extrude from....plzcontact me asap.

Mark · Post by **Mark** » Thu Sep 17, 2015 10:26 pm

Do you have a pic of the hotend?

jamest · Post by **jamest** » Sun Sep 20, 2015 9:58 am

: hotendsnh.jpg (6.16 KiB) Viewed 11861 times

yes

Mark · Post by **Mark** » Mon Sep 21, 2015 4:45 pm

the picture is too small to see the details...

jamest · Post by **jamest** » Mon Sep 21, 2015 8:31 pm

is this better ? see pla around hot end ... Oozed out from every seem but no pla extruded due to no holes . WTF ?Hot ends need to be replaced? fixed asap been working on this for way too long too may small issues that have kept me from using 3d printer.

jamest · Post by **jamest** » Mon Sep 21, 2015 9:18 pm

I used a magnifying glass & a tiny wire to check for holes & found that they were none. See around extruder "nozzle" pla has oozed from seem . TYPE of hot end has no way to exchange nozzle one piece. Is there a fix? exchange or replacement? I wish to get this working asap. been a long time waiting for this or that. missing part now hot ends without holes to extrude from.... Can I replace the hot end heat block & use a heat block that allows replacement of nozzles? or Am I going to need to replace complete hot ends? Are there better hot ends to replace these with from you, What can & will you do to help me get this working? I am frustrated

jamest · Post by **jamest** » Mon Sep 21, 2015 9:33 pm

can nozzles be replaced or do complete hot ends need to be replaced? see pla oozed from seems not from nozzle due to no hole to extruded from. best pics I was able to send due limits.

Mark · Post by **Mark** » Tue Sep 22, 2015 5:25 pm

You shoul contact the seller to replace them, replace the hotends not just nozzle.

jamest · Post by **jamest** » Sun Sep 27, 2015 7:50 am

they are taking care of it. good service. I never checked until too late lol.... glad they are helping me I would have had so much extra issues with out their help. so close to 1st print now....