A10T e steps : how to?

Post Reply
kendoodle
Posts: 1
Joined: Sat Oct 03, 2020 12:34 am

A10T e steps : how to?

Post by kendoodle » Sat Oct 03, 2020 12:51 am

I have not been able get a decent print on my new A10T. I've changed travel speed and restraction distance so many times and I still can't get a print without excessive stringing. I heard a YouTube blogger mention that e steps should be correct first but I have no idea how to do this. Is there a set number that needs to be changed in the printer's configuration or is there some kind of test that needs to be run to determine the correct setting? How can I get started fixing this so I can enjoy the full use of my printer. Thank you.

Post Reply

Who is online

Users browsing this forum: No registered users and 11 guests