Geeetech

Assembly of unit was no problem, but went to level the bed. when I select manual control nothing will happen. If I hit "Home" the Y stage moves until it hits the limit switch in the back then it will not do any moves. No Manual control in any direction, checked the limit switch it seems to work ok, not sure what to do from here, is there a support # or can someone call me? 865-384-1943

Hello,
1. You can check whether the y-axis stopper is properly connected.
2. You can test whether the endstop works normally.
http://geeetech.com/forum/viewtopic.php?f=17&t=60927
3. You can exchange the drive of the y-axis and other axes to see if it is a drive problem.

My prints have been coming out weird, some prints come out unfinished, and there is major stringing happening.

that's interesting .
im getting a few unfinished prints as well.
single colour no problems.
multi colour finishes before pint in complete

Hello, I've also trouble with multicolour.
I've read a long while ago someboday had made a online tool to modify colors in gcode but I can't find it anymore. Anybody?
Thx.
The mixing tool from geeetech shuts down each time.

William wrote: ↑

Fri Aug 28, 2020 1:49 pm

Hello,
1. You can check whether the y-axis stopper is properly connected.
2. You can test whether the endstop works normally.
http://geeetech.com/forum/viewtopic.php?f=17&t=60927
3. You can exchange the drive of the y-axis and other axes to see if it is a drive problem.

Thankyou so much this was very helful

William wrote: ↑

Fri Aug 28, 2020 1:49 pm

Hello,
1. You can check whether the y-axis stopper is properly connected.
2. You can test whether the endstop works normally.
http://geeetech.com/forum/worktime/viewtopic.php?f=17&t=60927
3. You can exchange the drive of the y-axis and other axes to see if it is a drive problem.

Thank You!