when plugging then x_m cable into the extruder socket I smelled burnt smoke and the printer stopped working. What should i do? Which piece should I exchange? Help me
Print model: A10T
Crash when connecting x_m cable into the socket of the extrusion
Crash when connecting x_m cable into the socket of the extrusion
- Attachments
-
- image.jpg (456.3 KiB) Viewed 6585 times
Re: Crash when connecting x_m cable into the socket of the extrusion
Hi, You can check if you can turn on the printer normally,
If it can be opened, what is the situation on the motherboard,
Check if there are signs of burnout.
Use a multimeter to measure the continuity of the wires you connect.
I hope this can help you.
If it can be opened, what is the situation on the motherboard,
Check if there are signs of burnout.
Use a multimeter to measure the continuity of the wires you connect.
I hope this can help you.
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!