Best budget 3D Printer ?

Post Reply
OmkarSawant
Posts: 1
Joined: Tue Aug 27, 2019 9:28 pm

Best budget 3D Printer ?

Post by OmkarSawant » Tue Aug 27, 2019 9:41 pm

Hey guys! I'm looking to purchase a budget 3D Printer but I'm new to this and need your help.

Essentially what I'll mostly be printing is magnetic connectors that require little (like 0.6 mm) holes on the top for wires to go through. So ideally I need a 3D Printer that has the necessary precision to print such small holes.

Thoughts? Recommendations?

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Best budget 3D Printer ?

Post by William » Wed Aug 28, 2019 9:19 am

Hi, You can choose from the official website according to your needs.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

User avatar
_kaktus_
Site Admin
Posts: 1260
Joined: Fri Dec 15, 2017 10:06 pm
Location: PL
Contact:

Re: Best budget 3D Printer ?

Post by _kaktus_ » Wed Aug 28, 2019 10:48 pm

Hello OmkarSawant.
:mrgreen:

You have specific requirements. Printing with such holes requires skill and the use of a nozzle with as small a diameter as possible.
That's what I think about it. :roll:

In my model I used nozzles with a hole of 0.3mm diameter.
The printouts were correct.
Smaller nozzle hole (0,2mm) did not allow for proper printing. :?

It's possible that a special version of the filament could be used then.
;)
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.

clay12
Posts: 2
Joined: Fri Aug 16, 2019 1:30 pm

Re: Best budget 3D Printer ?

Post by clay12 » Mon Sep 23, 2019 1:20 am

Hi OmkarSawant!

I recommend to read that helpful article. Good luck with your choice!

Jarda3d
Posts: 189
Joined: Sat Jan 26, 2019 8:42 am

Re: Best budget 3D Printer ?

Post by Jarda3d » Mon Sep 23, 2019 7:18 am

I print 0.5mm holes with A10. But you need to know how plastic do when it is layered in circle. So I use much bigger hole and then 0.5mm is printed. You should try how big hole you need in your 3D design, to be printed as 0.5mm. It depends on many factors, so you need to test it with your setup and material.
A10M Slic3r profile: here and fresh on github (lot of tips here)
A10 Slic3r profile: here
TIP: tight all screws and wheels (except right side of Z axis) and re-align frame while assembly. And silence it.

Post Reply