Temperature error

Post Reply
Posts: 1
Joined: Wed May 08, 2019 9:03 pm

Temperature error

Post by Cynthiagap » Wed May 08, 2019 9:21 pm

Good morning, I have almost a week with the printer A10M the first impressions was very good, but lately I have been having a problem with the temperature of the nozzle, when the piece starts the temperature is 200-210 for the PLA but as soon as a time goes down to 75 which makes the impression is wrong, the program I use to set the piece is CURA and I already check the printing parameters and they are fine, I look for information but I can not find anything, I hope I can have an opinion to what may be happening.
Thank you

User avatar
Site Admin
Posts: 5973
Joined: Tue Jun 07, 2016 9:38 am

Re: HELP¡¡ temperature error

Post by William » Thu May 09, 2019 9:35 am

-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests