Geeetech

Hi,

I installed a BL Touch and was trying to set the offset on the z axis s by using the M211 S0 command to disable the soft end stop.

For some reason this command does not work the board is a gt2560 on a geeetech I3 Pro B W.

Any help would be appreciated.

Robert

Hi,
Seems that marlin doesn't support "M211" code.
I guess you can set z offset directly by M851.

Was using Repetier which I found out does not support turning off the soft endstop.

I tried Easyprint 3D and worked no problems.

Thanks for the help.