When using to save as a .gco file, where should the print be in relation to the bed of the mini3d printer ?
for some reason mine when set to the centre prints at the top edge :(
any help would be appreciated.
cheers
Easy Print 3d software (E180)
Easy Print 3d software (E180)
Last edited by Dazza_UK on Thu May 10, 2018 4:44 am, edited 1 time in total.
Re: Easy Print 3d software
Hi,
1, What is your printer model?
2, Could you show us the print settings of the EasyPrint?
3, maybe you can attach the gcode file, then we can check it.
1, What is your printer model?
2, Could you show us the print settings of the EasyPrint?
3, maybe you can attach the gcode file, then we can check it.
Re: Easy Print 3d software
Hi,
1 , My model is : Geeetech E180 mini 3d Printer
2, Easy Print 3d settings :
Quality - High
Infill - 50%
Layer Height - 0.2mm
Temperature - 205c
support material - no
3, http://www.ukstrike.co.uk/grooty.rar
There are also some lines when sliced that run from the model, and for some reason, the 3d printer tries to run off and print these :(
Any advice you could give me will be a great help,
Many Thanks,
Dazza
1 , My model is : Geeetech E180 mini 3d Printer
2, Easy Print 3d settings :
Quality - High
Infill - 50%
Layer Height - 0.2mm
Temperature - 205c
support material - no
3, http://www.ukstrike.co.uk/grooty.rar
There are also some lines when sliced that run from the model, and for some reason, the 3d printer tries to run off and print these :(
Any advice you could give me will be a great help,
Many Thanks,
Dazza
Re: Easy Print 3d software (E180)
seems that it has gone beyond the print area.
Maybe you can check the settings and see if it is 130 * 130 * 130mm
Maybe you can check the settings and see if it is 130 * 130 * 130mm
- Attachments
-
- out of print area
- TIM图片20180510154841.png (6.85 KiB) Viewed 9253 times
-
- settings
- 130×130×130.png (23.71 KiB) Viewed 9253 times
Re: Easy Print 3d software (E180)
Ahh found it thanks,
It appears it wasnt profile set to E180 once I did that it set it properly.
Thanks for the heads up .
Dazza
It appears it wasnt profile set to E180 once I did that it set it properly.
Thanks for the heads up .
Dazza