Hi,
I am new to this hobby, I have lots to learn.
I just bought a Geeetech Prusa I3 M201 printer but I encountered a problem. The Control Board included in the kit in the "GTM32 pro Vb +5 A4988" so far so good.
When I checked the Building Instructions there is NOT discretion how or where to connect the Hotend (nozzels) 4 Red Cables (two of the attached to a connector as well as the two cable for the fan.
I guessing this is a simple problem but I would appreciate it could provide any advice.
Thank you for your help.
Best regards.
skywalker.
Connect Hotbed (nozzle) to GTM32 pro
Re: Connect Hotbed (nozzle) to GTM32 pro
You need to mount the hot-end on EXTRUDER CON V1.0 board.
https://www.youtube.com/watch?v=wu5EEv0 ... VQ-cbIUObs
https://www.youtube.com/watch?v=wu5EEv0 ... VQ-cbIUObs
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!