Connect Hotbed (nozzle) to GTM32 pro

Post Reply
skywalker
Posts: 0
Joined: Fri Oct 20, 2017 1:51 pm

Connect Hotbed (nozzle) to GTM32 pro

Post by skywalker » Sat Oct 21, 2017 6:47 pm

Hi,
I am new to this hobby, I have lots to learn.
I just bought a Geeetech Prusa I3 M201 printer but I encountered a problem. The Control Board included in the kit in the "GTM32 pro Vb +5 A4988" so far so good.
When I checked the Building Instructions there is NOT discretion how or where to connect the Hotend (nozzels) 4 Red Cables (two of the attached to a connector as well as the two cable for the fan.
I guessing this is a simple problem but I would appreciate it could provide any advice.
Thank you for your help.
Best regards.
skywalker.

User avatar
William
Site Admin
Posts: 6331
Joined: Tue Jun 07, 2016 9:38 am

Re: Connect Hotbed (nozzle) to GTM32 pro

Post by William » Mon Oct 23, 2017 9:59 am

You need to mount the hot-end on EXTRUDER CON V1.0 board.
https://www.youtube.com/watch?v=wu5EEv0 ... VQ-cbIUObs
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

MonicaSavage
Posts: 2
Joined: Fri Oct 23, 2020 7:53 pm

Re: Connect Hotbed (nozzle) to GTM32 pro

Post by MonicaSavage » Fri Oct 23, 2020 10:01 pm

If you want to read some EssayUSA reviews, then go to this website. Check out only real feedback from persons who ordered papers from their writers.

Post Reply

Who is online

Users browsing this forum: No registered users and 17 guests